B2217 - EVIC/EOM/CMTC INTERNAL
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on, internal self test routine running.
- Set Condition:
The Electronic Overhead Module fails one of seven internal tests.
| Possible Causes |
| ELECTRONIC OVERHEAD MODULE |
Diagnostic Test
1. VERIFY OPERATION OF THE ELECTRONIC OVERHEAD MODULETurn the ignition on.
With the scan tool, erase Electronic Overhead Module DTCs.
With the scan tool, activate the Electronic Overhead Module self test.
Wait for self test to complete.
With the scan tool, read Electronic Overhead Module DTCs.
Does the scan tool display: B2217–EVIC/EOM/CMTC INTERNAL?
YES
- Replace the Electronic Overhead Module in accordance with the service information.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
NO
- Test complete.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)