B210E-BATTERY VOLTAGE HIGH - DDM/PDM
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
At all times.
- Set Condition:
Anytime the module senses voltage input above 15.9 volts for over 15 seconds, this code will set.
| POSSIBLE CAUSES |
| HIGH VOLTAGE ENGINE DTC |
| DRIVER OR PASSENGER DOOR MODULE |
Diagnostic Test
1. CHECK ENGINE DTC'sWith the scan tool, read ENGINE DTC's
Are there any ENGINE DTC's present?
No
- Go to 2
Yes
- Refer to symptom list for problems related to ENGINE.
2. TEST FOR INTERMITTENT CONDITION
With the scan tool, record and erase DTC's
Start the engine and run for 2 minutes.
With the scan tool, read DTC's.
Does the scan tool display B210E-BATTERY VOLTAGE HIGH?
Yes
- Replace the appropriate Door Module.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)