C2206-CONFIGURATION ERROR (FDCM)
For a complete wiring diagram Refer to Section 8W
- When Monitored:
With the ignition on.
- Set Condition:
The Final Drive Control Module hardware check has determined that module configuration does not match vehicle configuration.
| Possible Causes |
| FINAL DRIVE CONTROL MODULE (FDCM) CONFIGURATION |
1. FINAL DRIVE CONTROL MODULE CONFIGURATION
The Final Drive Control Module hardware check has determined that module configuration does not match vehicle configuration. Verify that the correct module part number is installed in the vehicle.
Turn the ignition on.
With the Scan Tool, verify that the VIN stored in the controller matches the vehicle VIN.
With the Scan Tool, clear stored DTCs in the Final Drive Control Module.
Cycle the ignition off, then on.
With the Scan Tool, read DTCs in the Final Drive Control Module.
Does this DTC reset?
Yes
- Replace the Final Drive Control Module in accordance with the Service Information.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1 (Refer to 21 - TRANSMISSION/TRANSAXLE/TRANSFER CASE - STANDARD PROCEDURE).
No
- Test complete.
- Perform the TRANSFER CASE VERIFICATION TEST-VER 1 (Refer to 21 - TRANSMISSION/TRANSAXLE/TRANSFER CASE - STANDARD PROCEDURE).