B1A26-MAXIMUM NUMBER OF KEYS PROGRAMMED

For a complete wiring diagram Refer to Section 8W.

When Monitored:
With the ignition switch on.
Set Condition:
When the maximum number of key (8) have been programmed into the SKREEM

MAXIMUM AMOUNT OF KEY PROGRAMMED INTO SKREEM

Diagnostic Test

1. MAXIMUM AMOUNT OF KEYS PROGRAMMED INTO SKREEM

NOTE: The below procedure has you clearing all the key information within the SKREEM. It is important to obtain all the customer's ignition key(s) so they may be reprogrammed into the module.

Turn the ignition on.
Using a scan tool, clear all the key information in the SKREEM.
Program the all the customer key(s) into the SKREEM (up to eight only)

Was the “Maximum Number of Keys Programmed” display again?

Yes

Replace and program the SKREEM in accordance with the Service Information.

NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the SKREEM.

Perform SKREEM VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE)

Programming of the key(s) were successful. Test complete.
Perform SKREEM VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE)