B232D-WASHER SWITCH STUCK (SCM)
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
The SCM detects the Washer Switch in the STUCK state.
| Possible Causes |
| WIPER MULTIFUNCTION SWITCH |
| STEERING CONTROL MODULE |
Diagnostic Test
1. INTERMITTENT CONDITIONTurn the ignition on.
With the Scan Tool, clear all SCM DTC's.
Turn the Wipers ON then OFF.
With the Scan Tool, read the Wiper DTC's.
Does the Scan Tool read: B232D-WASHER SWITCH STUCK?
Yes
- Go To 2
No
- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
2. WIPER MULTIFUNCTION SWITCH
Turn the ignition off.
Using the correct service procedure, remove the Wiper Multi-Function Switch.
Measure the internal resistance of the Multifunction Switch between cavities 1 and 2. Move the switch into the WASH position while measuring.
WASH = 0 ohms
Is the resistance in the WASH position correct?
Yes
- Replace the Steering Control Module in accordance with the service information.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Replace the Multifunction Switch in accordance with the service information.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)