NO ANTENNA CONNECTION
For a complete wiring diagram Refer to Section 8W
- When Monitored:
With the ignition on and the radio in seek up/down mode.
- Set Condition:
With the radio in seek mode for two minutes and the radio does not detect an antenna connection or does not receive a radio station signal.
| Possible Causes |
| BAD ANTENNA CONNECTION |
| TEST ANTENNA |
| RADIO |
Diagnostic Test
1. BAD ANTENNA CONNECTIONTurn the ignition off.
Disconnect the Radio Antenna connector.
Inspect the Radio Antenna connection.
Was the Antenna connection clean and tight?
Yes
- Go To2
No
- Repair Antenna connection as needed.
- Perform BODY VERIFICATION TEST - VER 1.
2. TEST ANTENNA
Refer to the Audio System in the service information and test the Antenna in accordance with the service procedure.
Is the Antenna ok?
Yes
- Go To3
No
- Repair or replace the Antenna assembly as necessary.
- Perform BODY VERIFICATION TEST - VER 1.
3. RADIO
NOTE: Reconnect all previously disconnected components.
Turn the ignition and Radio on.
NOTE: Move vehicle outside approximately 30ft from any structure.
With the Scan Tool, erase the audio DTC's, put the radio in seek up and seek down mode for approximately 2 minutes before proceeding.
With the Scan Tool, read the audio DTC's.
Did this DTC reset?
Yes
- Replace the Radio.
- Perform BODY VERIFICATION TEST - VER 1.
No
- Test Complete.