AIRBAG INDICATOR
DESCRIPTION
An airbag indicator is standard equipment on all instrument clusters. However, the instrument cluster is programmed to automatically enable this indicator only on vehicles equipped with the airbag system, which is not available in some markets. The indicator is located above the fuel gauge and to the left of the speedometer in the instrument cluster overlay.
The airbag indicator consists of a stencil-like cutout of the text AIR BAG in the opaque layer of the instrument cluster overlay. The dark outer layer of the overlay prevents the indicator from being clearly visible when it is not illuminated. A red Light Emitting Diode (LED) behind the cutout in the opaque layer of the overlay causes the indicator to appear in red through the translucent outer layer of the overlay when it is illuminated from behind by the LED, which is soldered onto the instrument cluster electronic circuit board.
The airbag indicator is serviced as a unit with the instrument cluster.
OPERATION
The airbag indicator gives an indication to the vehicle operator when the airbag system, or a circuit or component of the system is ineffective. The airbag indicator is controlled by a transistor on the instrument cluster circuit board based upon cluster programming and electronic messages received by the cluster from the Airbag Control Module (ACM) over the Programmable Communications Interface (PCI) data bus.
The airbag indicator Light Emitting Diode (LED) is completely controlled by the instrument cluster logic circuit, and that logic will only allow this indicator to operate when the instrument cluster receives a battery current input on the fused ignition switch output (run-start) circuit. Therefore, the LED will always be OFF when the ignition switch is in any position except ON or START. The LED only illuminates when it is provided a path to ground by the instrument cluster transistor. The instrument cluster will turn ON the airbag indicator for the following reasons:
- Bulb Test - Each time the ignition switch is turned to the ON position the airbag indicator is illuminated for about six seconds. The entire bulb test is a function of the ACM.
- Airbag Indicator Lamp-On Message - Each time the cluster receives an electronic airbag indicator lamp-ON message from the ACM, the airbag indicator will be illuminated. The indicator remains illuminated for about 12 seconds or until the cluster receives a lamp-OFF message from the ACM, whichever is longer. This indicator will also be extinguished when the ignition switch is turned to the OFF position.
- Communication Error - If the cluster receives no lamp-ON or lamp-OFF messages from the ACM for six consecutive seconds, the airbag indicator is illuminated. The indicator remains illuminated until the cluster receives a single lamp-OFF message from the ACM.
- Actuator Test - Each time the cluster is put through the actuator test, the airbag indicator will be turned ON, then OFF again during the bulb check portion of the test to confirm the functionality of the LED and the cluster control circuitry. The actuator test illumination of the airbag indicator is a function of the instrument cluster.
The ACM continually monitors the airbag system circuits and sensors to decide whether the system is in good operating condition. The ACM then sends the proper lamp-ON or lamp-OFF message to the ElectroMechanical Instrument Cluster (EMIC). If the ACM sends a lamp-ON message after the bulb test, it indicates that the ACM has detected a system malfunction or that the airbags and seat belt tensioners may not deploy when required, or may deploy when not required. The ACM will store a Diagnostic Trouble Code (DTC) for any malfunction it detects. Each time the airbag indicator fails to illuminate due to an open or short in the cluster airbag indicator circuit, the cluster sends a message notifying the ACM of the condition, then the instrument cluster and the ACM will each store a DTC.
For proper diagnosis of the airbag system, the ACM, the EMIC, the PCI data bus or the electronic communication related to airbag indicator operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.