CLUSTER BUS TRANSMIT SHUTDOWN
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition in the Run/Start position.
- Set Condition:
The Instrument Cluster detects loss of internal bus transmission for 4 seconds.
| Possible Causes |
| INSTRUMENT CLUSTER |
Diagnostic Test
1. INSTRUMENT CLUSTERWith the scan tool, erase DTCs.
Cycle the ignition and wait approximately 1 minute.
With the scan tool, read DTCs.
Did this DTC reset?
Yes
- Replace the Instrument Cluster in accordance with the Service Information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Test Complete.