*SEAT BELT INDICATOR ALWAYS ON
For a complete wiring diagram Refer to Section 8W.
| Possible Causes |
| ACM DTC PRESENT |
| INSTRUMENT CLUSTER |
Diagnostic Test
1. ACM DTC PRESENTTurn the ignition on.
Ensure that the seat belt buckles are not damaged and are buckled.
With the scan tool select MIC, in Inputs/Outputs, read the Seatbelt Lamp state.
Does the scan tool display: ON?
Yes
- Refer to Seat Belt symptom(s) in the Airbag category.
No
- Replace and configure the Instrument Cluster in accordance with the Service Information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)