2007 Liberty KJ Factory Service Manual 8 - ELECTRICAL

LOW FUEL INDICATOR

DESCRIPTION



A low fuel indicator is standard equipment on all instrument clusters. This indicator is located above the fuel gauge and to the left of the speedometer in the cluster overlay.

The low fuel indicator consists of a stencil-like cutout of the International Control and Display Symbol icon for Fuel in the opaque layer of the instrument cluster overlay. The dark outer layer of the overlay prevents the indicator from being clearly visible when it is not illuminated. An amber Light Emitting Diode (LED) behind the cutout in the opaque layer of the overlay causes the indicator to appear in amber through the translucent outer layer of the overlay when it is illuminated from behind by the LED, which is soldered onto the instrument cluster electronic circuit board.

The low fuel indicator is serviced as a unit with the instrument cluster.

OPERATION

The low fuel indicator gives an indication to the vehicle operator when the level of fuel in the fuel tank becomes low. This indicator is controlled by a transistor on the instrument cluster circuit board based upon cluster programming and electronic messages received by the cluster from the Powertrain Control Module (PCM) over the Programmable Communications Interface (PCI) data bus.

The low fuel indicator Light Emitting Diode (LED) is completely controlled by the instrument cluster logic circuit, and that logic will only allow this indicator to operate when the instrument cluster receives a battery current input on the fused ignition switch output (run-start) circuit. Therefore, the LED will always be OFF when the ignition switch is in any position except ON or START. The LED only illuminates when it is provided a path to ground by the instrument cluster transistor. The instrument cluster will turn ON the low fuel indicator for the following reasons:

  • Bulb Test - Each time the ignition switch is turned to the ON position the low fuel indicator is illuminated for about three seconds as a bulb test.
  • Less Than 15 Percent Tank Full Message - Each time the cluster receives an electronic message from the PCM indicating that the percent tank full is less than 15, the low fuel indicator is illuminated. The indicator remains illuminated until the cluster receives messages from the PCM indicating that the percent tank full has increased to greater than 15. The PCM applies an algorithm to the input from the fuel tank sending unit to dampen the illumination of the low fuel indicator against the negative effect that fuel sloshing within the fuel tank can have on accurate inputs to the PCM.
  • Less Than Empty Percent Tank Full Message - Each time the cluster receives a message from the PCM indicating the percent tank full is less than EMPTY, the low fuel indicator is illuminated immediately. This message would indicate that the fuel tank sending unit input to the PCM is a short circuit.
  • More Than Full Percent Tank Full Message - Each time the cluster receives a message from the PCM indicating the percent tank full is more than FULL, the low fuel indicator is illuminated immediately. This message would indicate that the fuel tank sending unit input to the PCM is an open circuit.
  • Communication Error - If the cluster fails to receive a percent tank full message for more than about 12 seconds, the cluster control circuitry will illuminate the low fuel indicator until a new percent tank full message is received, or until the ignition switch is turned to the OFF position, whichever occurs first.
  • Actuator Test - Each time the cluster is put through the actuator test, the low fuel indicator will be turned ON, then OFF again during the bulb check portion of the test to confirm the functionality of the LED and the cluster control circuitry.

The PCM continually monitors the fuel tank sending unit input to determine the level of fuel in the fuel tank. The PCM then applies an algorithm to the input and sends the proper percent tank full messages to the ElectroMechanical Instrument Cluster (EMIC).

For proper diagnosis of the fuel tank sending unit, the PCM, the EMIC, the PCI data bus or the electronic communication related to low fuel indicator operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.