INSTRUMENT PANEL CENTER BEZEL
REMOVAL
1. Before proceeding with the following repair procedure, review all warnings and cautions. (Refer to 23 - BODY/INSTRUMENT PANEL - WARNING)
2. Remove the screw from inside the cubby bin next to the power outlet.
3. Using a trim stick C-4755 or equivalent, remove the center bezel (3) from the instrument panel assembly.
4. Disconnect the electrical and vacuum connectors.
INSTALLATION
1. Before proceeding with the following repair procedure, review all warnings and cautions. (Refer to 23 - BODY/INSTRUMENT PANEL - WARNING)
2. Connect the electrical and vacuum connectors.
3. Position the center bezel (3) and seat the retaining clips starting with the lower clips first.
4. Install the screw in the cubby bin next to the power outlet.