PRNDL MESSAGE NOT RECEIVED
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
The Hands Free Module does not receive a gear selector message from the TCM.
| Possible Causes |
| LOST COMMUNICATION WITH TCM |
| HANDS FREE MODULE |
Diagnostic Test
1. ATTEMPT TO COMMUNICATE WITH THE TCMTurn the ignition on.
Turn the radio on.
With the scan tool, attempt to communicate with the TCM.
Was the scan tool able to communicate with the TCM?
Yes
- Go To 2
No
- (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) and perform the related symptom.
2. ERASE DTC AND ATTEMPT TO RESET
With the scan tool, erase the HFM DTC's.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the scan tool, read the HFM DTC's.
Did this DTC reset?
Yes
- Replace and program the Hands Free Module in accordance with the service information.
- Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).
No
- The condition that set this DTC is no longer present. Using the wiring diagram/schematic as a guide, inspect the wiring for chafed, pierced, pinched, and partially broken wires and the wiring harness connectors for broken, bent, pushed out, and corroded terminals.