EVIC INTERNAL FAILURE
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
The EVIC detects an internal failure.
| Possible Causes |
| ELECTRONIC VEHICLE INFORMATION CENTER |
Diagnostic Test
1. ELECTRONIC VEHICLE INFORMATION CENTERTurn the ignition off.
Depress and hold the RESET and C/T buttons while turning the ignition on.
NOTE: This test may also be performed using the scan tool.
Does the EVIC or scan tool display "FAIL"?
Yes
- Replace the EVIC in accordance with the Service Information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Test Complete.