*AUTO DOOR LOCKS INOPERATIVE
For a complete wiring diagram Refer to Section 8W.
| Possible Causes |
| AUTO (ROLLING) DOOR LOCKS NOT ENABLED |
| DOOR AJAR STATUS |
| PCM DTC'S PRESENT |
| BODY CONTROL MODULE - AUTO LOCKS INOPERATIVE |
Diagnostic Test
1. READ AUTO DOOR LOCK STATUS ON SCAN TOOLWith the scan tool select: "Body Controller", "Miscellaneous", "Auto Door Locks"
Does the scan tool show "Auto Door Locks: ENABLED"?
Yes
- Go To2
No
- With the scan tool, enable the Auto (Rolling) Door Locks, open and close the driver door at least once and retest the System.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
2. CHECK DOOR AJAR STATES
Ensure all doors are closed.
With the scan tool read all DOOR AJAR states
Do any door ajar states show CLOSED?
Yes
- Refer to symptom list for problems related to DOOR AJAR.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Go To3
3. CHECK FOR PCM DTC's
With the scan tool read "Engine" DTC's.
Are there any TPS DTC's present?
Yes
- Refer to symptom list for problems related to DRIVEABILITY..
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Replace the Body Control Module in accordance with service information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)