SWITCH-FLIP-UP GLASS RELEASE

DIAGNOSIS AND TESTING - FLIP-UP GLASS RELEASE SWITCH

1. Disconnect and isolate the battery negative cable.
2. Remove the tailgate trim panel (Refer to 23 - BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/TRIM PANEL - REMOVAL).
3. Disconnect the wire harness connector.
4. Using an ohmmeter, check for continuity between the pins of the wire harness connector while pulling on the tailgate handle.
5. If no continuity is found, replace the tailgate handle assembly (Refer to 23 - BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/EXTERIOR HANDLE - REMOVAL).