*AIRBAG INDICATOR ON WITHOUT ACTIVE TROUBLE CODES
For a complete wiring diagram Refer to Section 8W.
| Possible Causes |
| ACTIVE INSTRUMENT CLUSTER (MIC) FAULTS |
| OCCUPANT RESTRAINT CONTROLLER (ORC) |
Diagnostic Test
1. VERIFY IF THE AIRBAG INDICATOR REQUEST STATUS IS ON OR OFFCAUTION: Diagnose and repair all active DTCs before performing this procedure.
NOTE: Ensure that the battery is fully charged.
Turn the ignition on.
With the scan tool in ORC, select Monitor Display and select Warning Lamp Status ORC.
Read the AIRBAG IND REQ BY ACM status.
Is the status ON?
Yes
WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and personal injury or death.
WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
- Replace the ORC in accordance with the Service Information.
- Perform the *AIRBAG SYSTEM VERIFICATION TEST - VER 1.
No
- (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - DIAGNOSIS AND TESTING) for problems related to Instrument Cluster.
- Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.