*AIRBAG SYSTEM VERIFICATION TEST - VER 1
For a complete wiring diagram Refer to Section 8W.
1. *AIRBAG SYSTEM VERIFICATION TEST - VER 1
1. Remove all special tools and jumper wires and reconnect all previously disconnected components - except the Battery.
WARNING: To avoid personal injury or death, turn the ignition on, then reconnect the battery.
- If repairs were made to the Occupant Classification System (OCS), perform the Belt Tension Sensor Verification Test in this Section before proceeding.
- Connect the scan tool to the Data Link Connector - use the most current software available.
- With the scan tool, erase stored DTCs in all Airbag System Modules.
- Turn the ignition off, and wait 15 seconds, then turn the ignition on.
- Wait one minute, and read active DTCs in all Airbag System Modules.
- Read the stored DTCs in all Airbag System Modules.
Are any DTCs present or if the original condition still present?
Yes
- Repair is not complete. Select the appropriate diagnostic procedure from the Table of Contents in this section.
No
- Repair is complete.