PASSENGER FLUID LEVEL TOO LOW
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
The Occupant Classification Module (OCM) will set this DTC if the Passenger Bladder Pressure Sensor input value is less than 25 A/D counts for more than 20 seconds.
| Possible Causes |
| PASSENGER BLADDER PRESSURE SENSOR SIGNAL CIRCUIT SHORTED TO VOLTAGE |
| SEAT BELT TENSION SENSOR POWER CIRCUIT SHORTED TO PASSENGER BLADDER PRESSURE SENSOR SIGNAL CIRCUIT |
| SEAT WEIGHT BLADDER AND PRESSURE SENSOR |
| OCM |
Diagnostic Test
1. REPLACE THE OCS BLADDER AND CUSHION KITNOTE: Ensure that the battery is fully charged.
Repair
WARNING: If the Occupant Classification Module (OCM) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and personal injury or death.
WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
NOTE: The Bladder and Cushion Kit are calibrated as an assembly. Do not disconnect the Bladder from the Cushion Kit. Service only as an assembly.
- Replace the OCS Bladder and Cushion Kit in accordance with the Service information.
- Perform SYSTEM VERIFICATION REQUIRED test.
- Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.