ITM-EEPROM FAILURE (EXPORT ONLY)
For a complete wiring diagram Refer to Section 8W
- When Monitored:
Continuously while the VTSS is armed and during change of the VTSS state.
- Set Condition:
If the EEPROM erase/write does not correctly complete the operation.
| Possible Causes |
| INTRUSION TRANSCEIVER MODULE (ITM) |
Diagnostic Test
1. VERIFY THAT THE DTC IS ACTIVETurn the ignition on.
With the scan tool, erase the ITM DTCs.
Turn the ignition off.
Arm the VTSS and wait one minute.
Disarm the VTSS and turn the ignition on.
With the scan tool, read ITM DTCs.
Did this DTC reset?
Yes
- Replace the ITM in accordance with the Service Information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).
No
- The condition that caused this symptom is currently not present. Test complete.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).