SKREEM/SKIM-INTERNAL FAULT
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
The SKREEM/SKIM has detected a fault during an internal self test.
| Possible Causes |
| SKREEM/SKIM INTERNAL DTC FAILURE |
Diagnostic Test
1. VERIFY THAT THE DTC IS ACTIVENOTE: This trouble code indicates an internal module fault.
Turn the ignition on.
With the scan tool, record and erase the SKREEM/SKIM DTCs.
Perform 5 ignition key cycles, leaving the ignition key on for a minimum of 90 seconds per cycle.
With the scan tool, read the SKREEM/SKIM DTCs.
Did this DTC reset?
Yes
- Replace and program the SKREEM/SKIM in accordance with the Service Information.
- Perform SKIS VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE).
No
- Test complete, the conditions that set this DTC are not present at this time.