FRONT DOOR OUTER BELT MOLDING
REMOVAL
1. Lower window completely.
2. Remove trim panel as necessary. (Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL - REMOVAL)
3. Insert special tool #9093 between belt molding and glass at rear and then slide tool forward approximately 14 cm (5.5 in.).
4. Push down on outer belt molding and rotate upper part of tool outward from vehicle approximately 6 – 8 cm (2.5 - 3 in.) then lift up on molding to disengage from locking tab.
5. Repeat step 3 and 4 at 28 cm (11 in.), 43 cm (17 in.), and 57 cm (22.5 in.) from rear of door.
6. Remove belt molding.
INSTALLATION
1. Press the belt molding onto the outer door window flange starting at the rear and working forward.
2. Install trim panel. (Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL - INSTALLATION)