CYLINDER - DOOR LOCK
REMOVAL
1. Remove the carrier plate, (Refer to 23 - BODY/DOOR - FULL FRONT/CARRIER PLATE - REMOVAL).
2. Remove the clip (3) and separate the lock cylinder (2) and gasket (1) from the door.
INSTALLATION
1. Assemble gasket (1) onto lock cylinder (2) until fully seated.
2. Install lock cylinder (2) into hole in outer door panel.
NOTE: Cylinder post must point forward.
NOTE: Cylinder drain hole must point down.
3. While holding lock cylinder (2) in place slide retainer clip (3) onto lock cylinder.
NOTE: Visually verify that pin on lock cylinder is engaged with bell crank 0n door module at door module install.
4. Install the carrier plate, (Refer to 23 - BODY/DOOR - FULL FRONT/CARRIER PLATE - INSTALLATION).