DOOR
REMOVAL
1. Remove the lower B-pillar trim panel (2), (Refer to 23 - BODY/INTERIOR/B-PILLAR TRIM - REMOVAL).
NOTE: Full front door shown, all others similar.
2. Open the door and disconnect the electrical connector at the B-pillar.
3. Separate the door harness from the footman's loop at the B-pillar.
4. Remove the nuts (1) and lift the door (2) up off hinges and remove.
INSTALLATION
NOTE: Full front door shown, all others similar.
1. Align pins on door hinge to holes in hinge on body and position door into place.
2. Install the nuts (1) and tighten to 8.5 N·m (75 in. lbs.).
3. Install the wire harness onto the footman loop and connect the electrical connector.
4. If necessary, adjust the door (Refer to 23 - BODY/DOOR-FRONT - ADJUSTMENTS).
5. Install the lower B-pillar trim (2), (Refer to 23 - BODY/INTERIOR/B-PILLAR TRIM - INSTALLATION).