SPECIFICATIONS
A/C SYSTEM
| Item |
Description |
Notes |
| A/C Compressor |
Zexel DKS-17DS |
ZXL-100 PAG Oil |
| Freeze-up Control |
Evaporator Temperature Sensor |
HVAC housing mounted - input to powertrain control module (PCM) or engine control module (ECM), depending on engine application |
| Low PSI Control |
A/C Pressure Transducer |
A/C discharge line mounted - input to powertrain control module (PCM) or engine control module (ECM), depending on engine application - PCM/ECM disengages compressor
clutch below 0.451 volts |
| High PSI Control |
A/C Pressure Transducer |
A/C discharge line mounted - input to powertrain control module (PCM) or engine control module (ECM), depending on engine application - PCM/ECM disengages compressor
clutch above 4.519 volts |
| High Pressure Relief Valve |
A/C Compressor mounted - opens at a discharge pressure over 3430 - 3930 kPa (497 - 570 psi) |
|
| R-134a Refrigerant Charge Capacity |
0.51 kg (1.125 lbs). |
Also see A/C Underhood Specification Label located in the engine compartment |
| A/C Clutch Coil Draw |
3.3 amps |
@ 12V ± 0.5V @ 25° C (77° F) |
| A/C Clutch Coil Resistance |
4.2 ± 0.2 ohms |
When measured across coil lead connector @ 25° C (77° F) |
| A/C Clutch Air Gap |
0.30 - 0.60 mm (0.012 - 0.024 in.) |
TORQUE
| Description |
N·m |
Ft. Lbs. |
In. Lbs. |
| All Screws NOT Listed Below |
1.2 |
– |
10 |
| A/C Compressor Bolts |
28 |
21 |
– |
| A/C Compressor Clutch Field Coil Screws |
5 |
– |
44 |
| A/C Compressor Shaft Bolt |
20 |
– |
177 |
| A/C Compressor Field Coil Connector Bracket Screw |
4.3 |
– |
38 |
| A/C Condenser to Radiator Bolts |
5 |
– |
45 |
| A/C Heater Control Screws |
2 |
– |
17 |
| Air Inlet Housing to Instrument Panel Support Bolts |
4 |
– |
35 |
| Blend Door Lever Screw |
0.6 |
– |
5 |
| Discharge Line to Condenser Nut |
23 |
17 |
– |
| Discharge Line to Compressor Nut |
23 |
17 |
– |
| Expansion Valve Bolts |
11 |
– |
97 |
| HVAC Housing to Instrument Panel Support Bolts |
4 |
– |
35 |
| Liquid Line to Condenser Nut |
23 |
17 |
– |
| Mode Door Cam Screw |
0.6 |
– |
5 |
| Receiver/Drier to Condenser Bolt |
22 |
16 |
– |
| Suction Line to Compressor Nut |
23 |
17 |
– |
| Suction and Liquid Lines to Expansion Valve Nut |
8 |
– |
70 |