B219F IGNITION OFF DRAW (IOD) FUSE BLOWN
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on. This DTC will only set if vehicle has over 50 miles on it.
- Set Condition:
IOD Fuse not installed or blown.
| Possible Causes |
| IOD FUSE NOT INSTALLED |
| IOD FUSE BLOWN |
Diagnostic Test
1. CHECK FOR ACTIVE DTCWith the scan tool, record and erase DTC's.
Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.
With the scan tool, read the active DTC's.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
2. IOD FUSE
Verify IOD Fuse installed in TIPM.
Is IOD Fuse present?
Yes
- Go To 3
No
- Replace the IOD Fuse.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
3. IOD FUSE BLOWN
Verify IOD Fuse is blown.
Is IOD Fuse blown?
Yes
- Using the wiring diagrams, diagnose for a short to ground condition.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Test complete.