B2208-OCCUPANT RESTRAINT CONTROLLER INTERNAL 2
- When Monitored:
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.
- Set Condition:
This DTC will set if the module identifies an out of range internal circuit.
| Possible Causes |
| OCCUPANT RESTRAINT CONTROLLER (ORC) |
Diagnostic Test
1. REPLACE OCCUPANT RESTRAINT CONTROLLERTurn the ignition on.
WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
WARNING: If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take proper precautions could result in accidental airbag deployment and serious or fatal injury.
Repair
- Replace the ORC in accordance with the Service Information.
- Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.