Linkage
DESCRIPTION
DESCRIPTION
The steering linkage consists of a pitman arm, drag link, tie rod, and steering damper. Adjustment sleeves are used on the tie rod and drag link for toe and steering wheel alignment.
The service procedures and torque specifications are the same for LHD and RHD vehicles.
STANDARD PROCEDURE - STEERING LINKAGE
STANDARD PROCEDURE - STEERING LINKAGE
| NOTE: |
LHD shown in graphics. The removal and installation procedures and torques specs are the same for the RHD. |
The tie rod end and ball stud seals should be inspected during all oil changes. If a seal is damaged, a complete replacement ball stud end should be installed.
If any steering components are
replaced or serviced an alignment must be performed, to ensure the
vehicle meets all alignment specifications.
CAUTION:
TORQUE
TORQUE
| DESCRIPTION | N·m |
Ft. Lbs. |
In. Lbs. |
|---|---|---|---|
|
Pitman Arm Shaft |
265 |
195 |
— |
|
Drag Link Ball Stud to Pitman Arm |
105 |
77 |
— |
|
Drag Link Ball Stud to Knuckle |
85 |
63 |
— |
|
Drag Link Adjuster Clamp |
35 |
26 |
— |
|
Tie Rod Ends Ball Studs |
85 |
63 |
— |
|
Tie Rod End Adjuster Clamp |
46 |
34 |
— |
|
Steering Damper to Axle |
68 |
50 |
— |
|
Steering Damper to Tie Rod |
68 |
50 |
— |
|
Steering Damper Bracket to Linkage |
50 |
37 |
— |
|
Track Bar Frame Bracket Nut |
169 |
125 |
— |
|
Track Bar Axle Bracket Bolt |
169 |
125 |
— |