B1472-CHANNEL 4 AUDIO SPEAKER OUTPUT CIRCUIT OPEN

For a complete wiring diagram, refer to the Wiring Information.

When Monitored:
Amplifier BUS wake-up. Amplifier reset with scan tool.
Set Condition:
The amplifier detects an open condition on the speaker output circuit.

Possible Causes
(X202) RIGHT FRONT SPEAKER (+) CIRCUIT OPEN
(X292) RIGHT FRONT SPEAKER (-) CIRCUIT OPEN
RIGHT FRONT SPEAKER
AMPLIFIER

1. CHECK FOR AN INTERMITTENT CONDITION

1.	Turn the ignition on.

2.	Using the scan tool, record and erase the Amplifier DTCs.

3.	Cycle the ignition switch from on to off, wait five seconds and then back to on.

4.	Turn the Radio on and set the volume to 25.

5.	Adjust the speakers to the front and center.

6.	Using the scan tool, read the active Amplifier DTCs.

Does the scan tool display active: B1472-CHANNEL 4 AUDIO SPEAKER OUTPUT CIRCUIT OPEN?

Yes

Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).

2. CHECK THE OPERATION OF THE RIGHT FRONT SPEAKER

1.	Turn the ignition off.

2.	Disconnect the Right Front Speaker harness connector.

3.	Turn the ignition on.

4.	Turn the radio on and turn the volume to 25.

5.	Adjust the speakers to the front and center.

6.	With a Voltmeter set to read in A/C voltage, measure the voltage of the Right Front Speaker circuits in the Right Front Speaker harness connector.

Is the voltage above 1 Volt?

Yes

Replace the Right Front Speaker in accordance with the Service Information.
Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).

3. CHECK THE (X202) RIGHT FRONT SPEAKER (+) CIRCUIT FOR AN OPEN

1.	Turn the ignition off.

2.	Disconnect the Amplifier C2 harness connector.

3.	Measure the resistance of the (X202) Right Front Speaker (+) circuit between the Amplifier C2 harness connector and the Right Front Speaker harness connector.

Is the resistance below 2.0 Ohms?

Yes

Repair the (X202) Right Front Speaker (+) circuit for an open.
Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).

4. CHECK THE (X292) RIGHT FRONT SPEAKER (-) CIRCUIT FOR AN OPEN

1.	Measure the resistance of the (X292) Right Front Speaker (-) circuit between the Amplifier C2 harness connector and the Right Front Speaker harness connector.

Is the resistance below 2.0 Ohms?

Yes

Replace the Amplifier in accordance with the Service Information.
Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).

Repair the (X292) Right Front Speaker (-) circuit for an open.
Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).