B2205-ORIGINAL VIN MISSING/MISMATCH
B2205-ORIGINAL VIN MISSING/MISMATCH
For a complete wiring diagram, refer to the Wiring Information.
Theory of Operation
-
When Monitored:
With the ignition on.
-
Set Condition:
The Occupant Restraint Controller (ORC) will receive and monitor the VIN message from the PCM and record the VIN if different from the last VIN.
Possible Causes |
|---|
| INCORRECT VIN PROGRAMMED IN PCM |
| OCCUPANT RESTRAINT CONTROLLER (ORC) |
1. VERIFY THAT DTC B2205-ORIGINAL VIN MISSING/MISMATCH
| NOTE: | Make sure the battery is fully charged. |
| 1. | Turn the ignition on. |
| 2. | With the scan tool, read ORC DTC. |
Does the scan tool display active B2205-ORIGINAL VIN MISSING/MISMATCH DTC?
Yes
- Go To 2
No
- If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
| 1. | With the scan tool compare the VIN that is programmed into the PCM to the VIN on the vehicle. |
Does the VIN programmed into the PCM match the vehicles VIN?
Yes
-
WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
-
WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the ORC in accordance with the service information.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure).
No
- Replace the Powertrain Control Module in accordance with Service Information.
-
Perform the POWERTRAIN VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM)
- Standard Procedure).