B2207-OCCUPANT RESTRAINT CONTROLLER INTERNAL 1
B2207-OCCUPANT RESTRAINT CONTROLLER INTERNAL 1
For a complete wiring diagram, refer to the Wiring Information.
Possible Causes
-
When Monitored:
With the ignition on. The Occupant Restraint Controller (ORC) on board diagnostics continuously performs internal circuit tests.
-
Set Condition:
This DTC will set if the ORC identifies an out of range internal circuit.
Possible Causes |
|---|
| INTERMITTENT SQUIB SHORTED TO GROUND |
| INTERMITTENT SQUIB SHORTED TO VOLTAGE |
| INTERMITTENT SQUIB OPEN |
| OCCUPANT RESTRAINT CONTROLLER (ORC) |
CHECK FOR SQUIB RELATED DTCS
| 1. | Turn the ignition on. |
| 2. | With the scan tool, read ORC DTCs. |
Is there any squib related DTCs present?
Yes
- Diagnose specified squib DTCs according to procedure in manual before diagnosing this DTC.
- (Refer to 28 - DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Diagnosis and Testing) and perform the appropriate diagnostic procedure.
No
-
WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
-
WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the ORC in accordance with the Service Information.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure).