U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA

For a complete wiring diagram, refer to the Wiring Information.

Possible Causes

When Monitored:
With the ignition on. The Occupant Restraint Controller (ORC) on board diagnostics continuously monitors the CAN Bus message from the TIPM containing the ORC configuration data.
Set Condition:
This DTC will set if the ORC configuration Bus message is invalid or missing.

Possible Causes
OCCUPANT RESTRAINT CONTROLLER (ORC)
TOTALLY INTEGRATED POWER MODULE (TIPM)

1. VERIFY TOTALLY INTEGRATED POWER MODULE (TIPM) OPERATION

1.	Turn the ignition on.

2.	With the scan tool, read TIPM DTCs.

Does the scan tool display any TIPM DTCs?

Yes

(Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing) and perform the active DTC diagnostic procedures in the TIPM before continuing with the ORC diagnostics.

Go To 2

2. CHECK OPERATION OF THE OCCUPANT RESTRAINT CONTROLLER

WARNING:

Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING:

If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

1.	Replace the Occupant Restraint Controller in accordance with the service information.

WARNING:

Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

2.	Use the most current software available. Connect the scan tool to the Data Link connector.

3.	Wait one minute, and read active codes and if there are none present read the stored codes.

Did the active U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA DTC return?

Yes

Replace the Totally Integrated Power Module (TIPM) in accordance with Service Information.
Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).

Repair is complete.
Perform the AIRBAG SYSTEM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure).