C1210-G SENSOR INPUT CIRCUIT PERFORMANCE

For a complete wiring diagram Refer to the Wiring Information.

When Monitored:
Continuously, with ignition on, until vehicle speed exceeds 20 km/h (12.4 m.p.h.) for the first time, but not if the sensor voltage is out of range.

Or, during diagnostic mode.

Or, if the monitoring was inhibited by a corresponding diagnostics command.
Set Condition:
If the measured acceleration signal is higher than 0.8 g for longer than the specified detection time.

Possible Causes
DYNAMICS SENSOR INSTALLATION
DYNAMICS SENSOR

CHECK FOR A DTC C1210-G SENSOR INPUT CIRCUIT PERFORMANCE

NOTE: This DTC must be active for the results of this test to be valid.

1.	Turn the ignition on.

2.	With the scan tool, read and record DTCs.

3.	With the scan tool, read and record Environmental Data to help identify the conditions in which the DTC was set.

4.	With the scan tool, erase DTCs.

5.	Cycle the ignition switch from off to on.

6.	With the scan tool, read and record DTCs.

Does the scan tool display: C1210-G SENSOR INPUT CIRCUIT PERFORMANCE?

Yes

Replace the Dynamics Sensor in accordance with the Service Information.
Perform ABS VERIFICATION TEST (Refer to 28 - DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure).