B1A3F-00-ITM ARMING SEQUENCE PERFORMANCE
B1A3F-00-ITM ARMING SEQUENCE PERFORMANCE
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
During the Vehicle Theft and Security System (VTSS) pre-arm process.
-
Set Condition:
Intrusion Transceiver Module (ITM) arming process did not complete in a predetermined amount time.
Possible Causes |
|---|
| INTERMITTENT CAN INTERIOR BUS COMMUNICATION |
| SOFTWARE UPDATE FOR ITM OR TIPM |
CHECK FOR AN ACTIVE DTC
| NOTE: | Diagnose any related Communication DTCs before continuing. |
| 1. | Turn the ignition off and remove the key from the ignition. |
| 2. | Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute. |
| 3. | Disarm the VTSS. |
| 4. | With the scan tool, read DTCs. |
Does the scan tool display this DTC as active?
Yes
- Check for and correct any CAN INTERIOR Bus DTCs set in the ITM or the TIPM. Also check for related software updates for the ITM and/or TIPM.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).