P062C-ETC LEVEL 2 MPH PERFORMANCE
P062C-ETC LEVEL 2 MPH PERFORMANCE
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
With the ignition on.
-
Set Condition:
The Powertrain Control Module (PCM) detects an error of the internal monitoring of the vehicle speed.
Possible Causes |
|---|
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
| NOTE: | If there are any vehicle speed DTCs present in the the PCM or any other modules, diagnose those DTCs before continuing with this test procedure. |
| 1. | Ignition on, engine not running. |
| 2. | With the scan tool, Clear DTCs in the PCM. |
| 3. | Cycle the ignition key off and on several times, leaving the ignition on for at least 10 seconds at a time. |
| 4. | Start the engine and test drive the vehicle. |
| 5. | With the scan tool, select View DTCs. |
Did the DTC return?
Yes
- Go To 2
No
- Perform the INTERMITTENT DTC diagnostic procedure. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
| 1. | Using the wiring diagram/schematic as a guide, inspect the Powertrain Control Module wiring and connectors. |
| 2. | Look for any chafed, pierced, pinched, or partially broken wires. |
| 3. | Look for broken, bent, pushed out or corroded terminals. |
| 4. | Perform any Technical Service Bulletins that may apply. |
Were any problems found?
Yes
- Repair as necessary.
- Perform the PCM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).
No
- Replace the Powertrain Control Module in accordance with the service information.
- Perform the PCM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure).