P1636-TCM INTERNAL- EXTERNAL WATCHDOG PERFORMANCE
P1636-TCM INTERNAL- EXTERNAL WATCHDOG PERFORMANCE
 |
For a complete wiring diagram, refer to the Wiring Information.
Theory of Operation
The Transmission Control Module (TCM) performs various internal tests to verify proper controller operation. This DTC indicates that watchdog circuitry external to the microprocessor has detected an error. If the TCM watch dog circuitry external to the microprocessor detects an error, the controller will enter Limp-in mode and illuminate the MIL.
-
When Monitored:
Continuously with the ignition on.
-
Set Condition:
If the TCM watchdog circuitry external to the microprocessor detects an error.
Possible Causes |
|---|
| TRANSMISSION CONTROL MODULE (TCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 28 - DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure).
TRANSMISSION CONTROL MODULE (TCM)
Repair
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the Service Information.
- Perform the NAG1 TRANSMISSION VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure).