B1A0A-RKE FOB 3 PERFORMANCE
B1A0A-RKE FOB 3 PERFORMANCE
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
Continuously.
-
Set Condition:
Scrambled messages to the Wireless Control Module from the transmitter.
NOTE: The most probable cause for this code to set is if the Wireless Control Module (WCM) senses over 150 presses from the RKE transmitter, when it is out of range.
Possible Causes |
|---|
| EXCESSIVE PRESSES FROM TRANSMITTER WHEN OUT OF RANGE |
| RKE TRANSMITTER |
TEST FOR INTERMITTENT CONDITION
| 1. | Put the key in the ignition and turn the ignition on. |
| 2. | With the scan tool, record and erase DTCs |
| 3. | Operate the RKE transmitter in all positions several times. |
| 4. | With the scan tool, read DTCs. |
Does the scan tool display this code as active?
Yes
- Replace the RKE transmitter and program in accordance with Service Information.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure)
No
- The conditions that caused this code to set are not present at this time. Inform the owner of the most probable cause for this code to set and therefore cause the RKE system to be inoperative.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure)