B1A24-KEY NOT PROGRAMMED
B1A24-KEY NOT PROGRAMMED
For a complete wiring diagram, refer to the Wiring Information.
Possible Causes |
|---|
| KEY NOT PROGRAMMED |
| WIRELESS CONTROL MODULE (WCM)/SENTRY KEY REMOTE ENTRY MODULE (SKREEM) |
PROGRAM ALL OF THE IGNITION KEYS
| 1. | Turn the ignition on. |
| 2. | With the scan tool, attempt to program the key(s) into the WCM/SKREEM. |
Was the programming of the key(s) successful?
Yes
- Perform the WCM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Wireless Control (WCM) - Standard Procedure)
No
-
Replace the ignition key and attempt to program it into the WCM/SKREEM. If the DTC resets, replace and program the Wireless Control Module Module (WCM/SKREEM) in accordance with the Service Information.
NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the WCM. - Perform the WCM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Wireless Control (WCM) - Standard Procedure)