C1571-FRONT SWAY BAR SWITCH PERFORMANCE
C1571-FRONT SWAY BAR SWITCH PERFORMANCE
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
With the ignition on.
-
Set Condition:
The Cluster detects the Front Sway Bar Switch active for greater than 20 seconds.
Possible Causes |
|---|
| UPPER SWITCH BANK |
CHECK FOR AN ACTIVE DTC
| 1. | Turn the ignition on. |
| 2. | Press the Front Sway Bar Switch three times. |
| 3. | With the scan tool, read DTCs. |
Does the scan tool display this DTC as active?
Yes
- Replace the Upper Switch Bank in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).