B142E-GPS ANTENNA NOT CONNECTED

For a complete wiring diagram, Refer to the Wiring Information.

When Monitored:
With the ignition on and the Radio in Navigation mode.
Set Condition:
With the Radio in Navigation mode. The Radio does not detect an Antenna connection or does not receive a Navigation (GPS) signal.

1. TEST ANTENNA

1.	Turn the ignition off.

2.	Disconnect the GPS Antenna connector.

3.	Inspect the GPS Antenna connection.

Was the Antenna connection clean and secure?

Yes

2. ANTENNA

1.	Refer to the Audio System in the Service Information and test the antenna in accordance with the Service Procedure.

Is the Antenna ok?

Yes

Repair or replace the Antenna assembly in accordance with the Service Information.
Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure)

3. RADIO

NOTE: Reconnect all previously disconnected components.

NOTE: Move vehicle outside approximately 30ft (9.14m) from any structure.

1.	Turn the ignition and Radio on.

2.	With the scan tool, clear all DTC's and operate the Navigation system.

3.	With the scan tool, read DTC's.

Does the scan tool display active: B142E-GPS ANTENNA NOT CONNECTED?

Yes

Replace the Radio in accordance with the Service Information.
Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure)