2012 Jeep Wrangler JK Factory Service Manual 14 - Fuel System

SENSOR, Intake Air Pressure

REMOVAL

REMOVAL

The Intake Air Pressure Sensor (5) is located on the air cleaner cover (1).

  1. Disconnect the negative battery cable.

    2.  
  2. Disconnect the Intake Air Pressure (IAP) sensor wire harness connector (4).

    3.  
  3. Remove fasteners and the IAP sensor.

    4.  

INSTALLATION

INSTALLATION

  1. Check condition of sensor O-ring.

    2.  
  2. Install the Intake Air Pressure (IAP) sensor (5) and securely tighten fasteners.

    3.  
  3. Install IAP sensor wire harness connector (4).

    4.  
  4. Connect the negative battery cable.

    5.