FLUID
DESCRIPTION
DESCRIPTION
The recommended fluid for the power steering system is Mopar® ATF +4.
Mopar® ATF+4, when new is red in color. The ATF+4 is dyed red so it can be identified from other fluids used in the vehicle such as engine oil or antifreeze. The red color is not permanent and is not an indicator of fluid condition, As the vehicle is driven, the ATF+4 will begin to look darker in color and may eventually become brown. THIS IS NORMAL. ATF+4 also has a unique odor that may change with age. Consequently, odor and color cannot be used to indicate the fluid condition or the need for a fluid change.
STANDARD PROCEDURE - POWER STEERING FLUID LEVEL CHECKING
STANDARD PROCEDURE - POWER STEERING FLUID LEVEL CHECKING
Fluid level should be checked with
the engine off to prevent personal injury from moving parts.
WARNING:
MOPAR® ATF+4 is to be used in
the power steering system. No other power steering or automatic transmission
fluid is to be used in the system. Damage may result to the power
steering pump and system if any other fluid is used, and do not overfill.
CAUTION:
The power steering fluid level can be viewed on the dipstick attached to the filler cap. There are two ranges listed on the dipstick, COLD and HOT. Before opening power steering system, wipe the reservoir filler cap free of dirt and debris. Remove the cap and check the fluid level on its dipstick. When the fluid is at normal ambient temperature, approximately 21°C to 27°C (70°F to 80°F), the fluid level should read between the minimum and maximum area of the cold range. When the fluid is hot, fluid level is allowed to read up to the highest end of the HOT range. Only add fluid when the vehicle is cold.
Use only Mopar® ATF+4. Do not overfill the power steering system.