2012 Jeep Wrangler JK Factory Service Manual 21 - Transmission and Transfer Case

SEAL, Output Shaft, Extension Housing

REMOVAL

REMOVAL

  1. Raise and support vehicle.

    2.  
  2. Remove rear propeller shaft. (Refer to 03 - Differential and Driveline/Propeller Shaft/SHAFT, Drive - Removal)

    3.  
  3. Using a suitable pry tool or slide-hammer mounted screw, remove the extension housing seal.

    4.  

INSTALLATION

INSTALLATION

Special Tools: Click to display a list of tools used in this procedure

  1. Clean fluid residue from sealing surface and inspect for defects.

    2.  
  2. Using Seal Installer D-163 (2) and Universal Handle C-4171 (1), install seal in extension housing .

    3.  
  3. Install propeller shaft. (Refer to 03 - Differential and Driveline/Propeller Shaft/SHAFT, Drive - Installation)

    4.  
  4. Verify proper transfer case fluid level.

    5.  
  5. Lower vehicle.

    6.