B2209-OCCUPANT RESTRAINT CONTROLLER INTERNAL 3
Possible Causes
-
When Monitored:
With the ignition on. The Occupant Restraint Controller (ORC) on board diagnostics continuously performs internal circuit tests.
-
Set Condition:
This DTC will set if the ORC identifies an out of range internal circuit.
Possible Causes |
|---|
| OCCUPANT RESTRAINT CONTROLLER (ORC) |
REPLACE OCCUPANT RESTRAINT CONTROLLER
Turn the ignition off, disconnect
the 12-volt battery and wait two minutes before proceeding. Failure
to follow these instructions may result in possible serious or fatal
injury.
WARNING:
If the Occupant Restraint Controller
(ORC) is dropped at any time, it must be replaced. Failure to follow
these instructions may result in possible serious or fatal injury.
WARNING:
Repair
- Replace the ORC in accordance with the Service Information.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure).