STANDARD PROCEDURE - AIRBAG SYSTEM VERIFICATION TEST
AIRBAG SYSTEM VERIFICATION TEST
| 1. | Remove all special tools and jumper wires and reconnect all previously disconnected components, except the battery. |
Turn the ignition on, then reconnect
the 12-volt battery and wait two minutes before proceeding. Failure
to follow these instructions may result in possible serious or fatal
injury.
WARNING:
| 2. | Connect the scan tool to the Data Link Connector - use the most current software available. |
| 3. | With the scan tool, erase stored DTCs in all Airbag System Modules. |
| 4. | Turn the ignition off, and wait 30 seconds, then turn the ignition on. |
| 5. | Wait one minute, and read active DTCs in all Airbag System Modules. |
| 6. | Read the stored DTCs in all Airbag System Modules. |
Are any DTCs present or if the original condition still present?
Yes
- Repair is not complete. Select the appropriate diagnostic procedure from the Table of Contents. (Refer to 28 - DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Diagnosis and Testing).
No