U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA
For a complete wiring diagram, refer to the Wiring Information.
Possible Causes
-
When Monitored:
With the ignition on. The Occupant Restraint Controller (ORC) on board diagnostics continuously monitors the CAN Bus message from the TIPM containing the ORC configuration data.
-
Set Condition:
This DTC will set if the ORC configuration Bus message is invalid or missing.
Possible Causes |
|---|
| OCCUPANT RESTRAINT CONTROLLER (ORC) |
| TOTALLY INTEGRATED POWER MODULE (TIPM) |
1. VERIFY TOTALLY INTEGRATED POWER MODULE (TIPM) OPERATION
| 1. | Turn the ignition on. |
| 2. | With the scan tool, read TIPM DTCs. |
Does the scan tool display any TIPM DTCs?
Yes
- (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing) and perform the active DTC diagnostic procedures in the TIPM before continuing with the ORC diagnostics.
No
- Go To 2
2. CHECK OPERATION OF THE OCCUPANT RESTRAINT CONTROLLER
Turn the ignition off, disconnect
the 12-volt battery and wait two minutes before proceeding. Failure
to follow these instructions may result in possible serious or fatal
injury.
WARNING:
If the Occupant Restraint Controller
(ORC) is dropped at any time, it must be replaced. Failure to follow
these instructions may result in possible serious or fatal injury.
WARNING:
| 1. | Replace the Occupant Restraint Controller in accordance with the service information. |
Turn the ignition on, then reconnect
the 12-volt battery and wait two minutes before proceeding. Failure
to follow these instructions may result in possible serious or fatal
injury.
WARNING:
| 2. | Use the most current software available. Connect the scan tool to the Data Link connector. |
| 3. | Wait one minute, and read active codes and if there are none present read the stored codes. |
Did the active U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA DTC return?
Yes
- Replace the Totally Integrated Power Module (TIPM) in accordance with Service Information.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).
No
- Repair is complete.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure).