For a complete wiring diagram, refer to the Wiring Information.
When Monitored:
With vehicle speed above 7 mph (11 km/h), but not if the sensor signal is invalid.
Set Condition:
If the Anti-Lock Brake Module detects implausible Dynamics Sensor values.
Possible Causes
WIRING HARNESS, TERMINAL, CONNECTOR DAMAGE
DYNAMICS SENSOR INSTALLATION
DYNAMICS SENSOR
1.
VERIFY DTC IS ACTIVE
NOTE:
If present, diagnose and repair DTC C2114-DYNAMICS SENSOR SUPPLY VOLTAGE LOW or DTC C2115-DYNAMICS SENSOR SUPPLY VOLTAGE HIGH before diagnosing this DTC.
1.
Turn the ignition on.
2.
With the scan tool, read and record the ABS DTCs.
3.
With the scan tool, read and record the Environmental Data to help identify the conditions in which the DTC was set.
4.
With the scan tool, erase the ABS DTCs.
5.
Cycle the ignition switch.
WARNING:
Make sure brake capability is available
before road testing.
6.
Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 6 and 12 mph (10 and 20 km/h).
The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched or partially broken wires.
