C2205-STEERING ANGLE SENSOR INTERNAL
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
With ignition on, but not if supply voltage faults are detected.
-
Set Condition:
If the Anti-Lock Brake System (ABS) Module detects that the Steering Angle Sensor sends an internal failure message.
Possible Causes |
|---|
| CLOCKSPRING SAS) |
CHECK FOR A DTC C2205-STEERING ANGLE SENSOR INTERNAL
| NOTE: | This DTC must be active for the results of this test to be valid. |
| 1. | Turn the ignition on. |
| 2. | With the scan tool, read and record DTCs. |
| 3. | With the scan tool, read and record Freeze Frame information. |
| 4. | With the scan tool, erase DTCs. |
Make sure brake capability is available
before road testing.
WARNING:
| 5. | Start the vehicle and turn the wheel from lock to lock. |
| 6. | Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 25 km/h (6 and 15 mph). |
| 7. | Park the vehicle. |
| 8. | With the scan tool, read and record DTCs. |
Does the scan tool display: C2205-STEERING ANGLE SENSOR INTERNAL?
Yes
- Replace the Clockspring in accordance with the Service Information. The Steering Angle Sensor is internal to the Clockspring.
- Perform the ABS VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure).
No
- Perform the ABS INTERMITTENT CONDITION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure).