U0429-IMPLAUSIBLE DATA RECEIVED FROM SCM
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
With ignition on, but not if low voltage is detected.
Or, if a CAN Bus off event is detected.
-
Set Condition:
If the Anti-Lock Brakes Module detects either the sequence or integrity of the Steering Angle Sensor messages is invalid.
Possible Causes |
|---|
| CAN C BUS CIRCUIT(S) SHORTED |
| LOAD TOO HIGH ON CAN C BUS |
| STEERING ANGLE SENSOR DTCs PRESENT |
| ANTI-LOCK BRAKES MODULE |
1. CHECK IF COMMUNICATION RELATED DTCs ARE PRESENT
| 1. | Turn the ignition on. |
| 2. | With the scan tool, read ABS DTCs. |
Are any Communication related DTCs present?
Yes
- Diagnose and repair the DTC(s). (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing).
No
- Go To 2
2. CHECK IF OTHER STEERING ANGLE SENSOR RELATED DTCs ARE PRESENT
| 1. | With the scan tool, read ABS DTCs. |
Are any other STEERING ANGLE SENSOR DTCs present?
Yes
- Diagnose and repair the DTC(s). Refer to the Table of Contents in this Section for a complete list of symptoms.
No
- Replace the Clockspring in accordance with the Service Information.
- Perform the ABS VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure).