B2206-CURRENT VIN MISSING/MISMATCH
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
Anytime the ignition key is in the ON position.
-
Set Condition:
VIN stored in Intrusion Transceiver Module (ITM) does not match the VIN stored in the Cluster.
Possible Causes |
|---|
| INTRUSION TRANSCEIVER MODULE SWAPPED FROM DIFFERENT VEHICLE |
DETERMINING IF DIAGNOSTIC TROUBLE CODE (DTC) IS CURRENT
| 1. | With a scan tool, read and record DTC. |
| 2. | With the scan tool, clear DTC. |
| 3. | Turn the ignition off and remove the key from the ignition. |
| 4. | Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute. |
| 5. | Disarm the VTSS. |
| 6. | Turn the ignition on. |
| 7. | Using the scan tool under miscellaneous functions initialize the Intrusion Transceiver Module. |
| 8. | Using the scan tool, read DTCs. |
Does the scan tool display this DTC as active?
Yes
- Replace the ITM in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).