U140E-00-IMPLAUSIBLE VEHICLE CONFIGURATION DATA RECEIVED
For a complete wiring diagram, refer to the Wiring Information.
-
When Monitored:
Continuously with the ignition on.
-
Set Condition:
The Intrusion Transceiver Module (ITM) receives incorrect vehicle configuration information from the Totally Integrated Power Module (TIPM).
Possible Causes |
|---|
| CAN BUS DTCS SET IN TOTALLY INTEGRATED POWER MODULE (TIPM) |
| INTRUSION TRANSCEIVER MODULE (ITM) |
| 1. | Turn the ignition on. |
| 2. | With the scan tool, read DTCs. |
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).
2. CAN BUS DTCS SET IN TOTALLY INTEGRATED POWER MODULE (TIPM)
| NOTE: | Verify that the TIPM has the correct vehicle configuration before proceeding with this test step. |
| 1. | With the scan tool, read DTCs in the TIPM. |
Are there any active CAN Bus DTCs present?
Yes
- (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing) and perform the appropriate diagnostic procedure.
No
- Replace the ITM in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. (Refer to 28 - DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure).